mainesysadmin.com

For a task that is REALLY easy it took a more googling than I had anticipated to come up with the solution.  Once your volume has been delivered to the server it is important to initialize the disk but not to create any partitions.

1. Open Windows Disk management.
2. Click Action -> Rescan disks to make your new disk appear, if greater than 2tb it will appear as 2 partitions on 1 disk
3. Right click on the disk and initialize the disk
4. Open a windows command prompt
5. type “diskpart”
6. type “list disk”
7. select the new disk that’s over 2tb
8. convert gpt
9. Now from windows Disk Management you should see a single disk greater than 2tb

Information on the diskpart utility:   http://support.microsoft.com/default.aspx/kb/300415

The most important prereqs include Windows 2k3 is up to at least sp1 and that no partitions exist on the disk.

Scott featured a nice write up comparison of ESX nic utilization and vSwitch configuration the other day.  The article is specifically around the Guest VM vSwitch and compares the differences between Link Aggregation and the opposite.  It’s a useful reminder of the load balancing characterists of the different settings in the vSwitch.

This was a two part series on his webpage:

Part 2: http://blog.scottlowe.org/2008/10/08/more-on-vmware-esx-nic-utilization/

Part 1: http://blog.scottlowe.org/2008/07/16/understanding-nic-utilization-in-vmware-esx/

I love lifehacker.com.  I always find usefull posts like this one below.

http://lifehacker.com/5057484/remove-u3-to-speed-up-your-flash-drive

This is very useful for us Linux users.  It’s so annoying to plug a u3 drive into a linux o/s.  Anyhow download the utility and clean up your U3 enabled usb thumb drive here:  http://www.u3.com/uninstall/default.aspx

Before recently I had not required to publish any flash animations with a windows server running IIS6.  Come to find out that it is really easy to do.  I ran across the following blog below with the correct information.  I’ll include the steps below the url for posterity.

http://it.toolbox.com/blogs/rymoore/adding-flv-mime-type-in-iis-4198

Adding .flv MIME type in IIS

1) Select the site to configure in IIS, right click and select “Properties”
2) Under HTTP Headers Tab, select “File Types” under the MIME Map section and select “New Type”
3) Type “.flv” as the associated extension and “video/x-flv” as the content type.
4) Select “OK” and you’re ready to fly!